Techniques to Make the Windows XP Installer CD for SATA Hard Disk.

Teknik atau cara membuat Master Windows XP untuk Hard Disk SATA.
The steps to make the Windows XP installer CD in order to detect SATA hard disk on the notebook or laptop.
Before we begin the steps necessary to prepare some software and equipment we need. that is:

Master CD Installer Windows XP.
Blank CDs.
Computers or Notebook can burning.
Disk space for Master Windows XP (approximately 700 MB)
NLiteOS software (can download here)
SATA drivers (download link here)

After the software and equipment prepared, follow the steps below:

Install NLiteOS Software on your computer.
If you have not installed the computer netframework 2, install first netframework 2. (can be download here).
Copy Master the Windows XP CD into Drive C on the computer or your laptop and give the folder a name that is almost similar to windows, for example in C: \ WINSATA
copy SATA drivers which we prepare in the directory, eg in C: \ WINSATA \ satadrv.
Run the program nLiteOS Software and enter Blank CD into the CD-RW and follow the steps as below:

Choose the language is used like the following picture:

PATH Navigate to the folder your created, for example C: \ WINSATA like this picture below. the nLiteOS will detect a series of Windows XP Installer and then press Next button.

After the display appears as below, ignore and click Next button.

After the display appears as below, click on the Driver until circle is green, which means we will insert the CD into the driver installer and click also Bootable ISO to CD Blank to burning to which we have prepared earlier on the CD-RW. Then press Next.

After the show window as below the Insert button and select a single driver will only enter if specific driver, or select multiple drivers if we would put all the drivers, then navigate to the folder SATA drivers we had copy. Single drivers for SATA hard drive type, while multiple drivers specifically for this type of SATA hard disk common.

After we put the drivers into the list and then press Next, and the display will appear as below it. and select yes to proceed.

After the process is complete, press next to continue.
After the display appears as below, select Burn Image mode if we are going directly to CD or burning select Create Image mode if we can just make an ISO image only. then press Next.